The ERT100 Earth Resistance Tester is a professional instrument for measuring the resistance of 2-wire electrical equipment safety grounds. With a large LCD display and simple controls, the ERT100 is valuable in verifying the lightening safety earth connection of new or existing control systems. The tester can store up to 100 sets of measurement data.
- 2-Wire Certification
- Large digital and analog display
- Two pole and three pole earth resistance test modes
- Earth resistance range 0 – 4,000 ohms
- Earth voltage safety check
- Earth resistance constant current inverter 800HZ approx. 3 mA
- 100 results data memory
- Carry Bag with Shoulder Strap
- Low battery voltage indication
- Backlight
Our Easy to Use Digital Multimeter
If you’re searching for a general-purpose multimeter for identifying wiring faults, look no further than Armada’s Pro32™ Digital Multimeter. Test capability includes resistance, amperage, and either AC or DC voltage. The Pro32™ comes with a troubleshooting cheat sheet for irrigation included in the package. The first meter to use in troubleshooting electrical problems is a multimeter. The Pro32 is affordable and easy to use, featuring automatic range capability. Tests include resistance, amps, and AC or DC voltages.
On-the-Go Simplicity
Multimeters are extremely handy when it comes to determining whether the electrical circuit problems. The Pro32 can determine faulty electrical outlets, bad wiring, bad transformers, controller output, or solenoid condition in seconds.
Quality You Can Count On
We know there are a lot of inexpensive multimeters out there, but the Pro32™ offers the best value for several reasons, including the fact that the leads (or red and black cords) wrap around the body of the tester and snap into place when they’re not in use. This keeps them organized, protected, and out of the way. The Pro30™ also comes with a protective case and an A23 battery.
Specifications:
- DCV: 0-500V
- ACV: 0-500V
- DCA: 0-200mA
- Resistance: 0-2Mohm
- Audible continuity: <50ohmDiode test
- Battery: A23 (included)
The Pro300P™ Propane Tracer Wire Locator is a simple, easy-to-use tool designed to track tracer wires in underground applications. The Pro300P™ consists of a case installed, integrated transmitter and handy, light receiver combination with volume control. The 2 kHz frequency, null tracking signal, and setup are simple for any beginner but powerful enough to please any seasoned user.
The Pro300P™ Residential Wire and Valve Locator is a value-packed tool for contractors working with shorter wiring like residential sprinklers, landscape lighting or invisible fences. The Pro300P consists of a transmitter and receiver combination just like its big brothers, the Pro700 and Pro800D, but uses a smaller power output to match smaller jobs. The 1748 Hz frequency, null tracking, signal, and setup are exactly the same as the Pro700. Designed to keep within a budget, the pricing is small as well.
Simply connect the Pro300P™ to the wire to be tracked and to the ground stake in dirt, get a good ground indication, and track the beeps with the hand held receiver. It’s that easy.
Major Bullets:
- Shielded, Rubberized Alligator Clip Boots Included
- Tracks Trace Wires, Residential Sprinkler Wires, and Solenoids
- Uses Standard 1748 Hz Null Tracking Signal.
- Transmitter Automatic Off Switch.
- Uses eight (8) ‘C’ Batteries and one 9 volt (not included).
The Pro66™ Tracking Aid is a device designed to allow users to track the path up to 98 feet of a non-metallic pipe or conduit buried in the ground or routed in walls. When used in conjunction with wire trackers like the Armada 33 kHz Pro290™, Pro881™, or Pro900™, it is possible to determine the route of PVC or vinyl conduit whether they are empty or have fluid in them.
- For conduit or pipe runs up to 98 feet
- The thin 3 mm diameter fiberglass tracking rod stows in the disc-like outer case
- The tracker rod offers flexible, replaceable tips and pulling eyes of different diameters
- Can be used to insert pull string in a conduit
- Works best with 33 kHz or higher wire trackers
- Convenient 4 mm receptacle for the transmitter connection from the tracker
- No separate power required for the Tracking Aid
Easier, faster, less complicated, …and with digital performance.
The Pro881™ Underground Cable Locator is an easy, fast operating digital locator designed to get the job done quickly and accurately. Minimal settings make the Pro881™ a great choice for new or seasoned maintenance staff. Incorporating three different locating frequencies, the Pro881™ tracks many types of cabling, including irrigation, CATV, electrical, telephone, and lighting. The Pro881™ incorporates digital reception filtration to eliminate unwanted AC noise and interference for efficient, uncomplicated locates.
The Pro881™ includes the IC4 inductive clamp, injecting a 175 kHz tracing signal onto energized or de-energized cabling while the digital filters remove signals that are not desired. Inductive locating allows non-contact connection of tracing signal, avoiding dangerous electrical voltages or disconnection of traced cable.
Features
- Digital Signal and Noise Rejection
- Simple 3 Button Transmitter
- 3 Transmission Frequencies
- 3 Connection Methods
- Null or Peak Tracking
- Easy to Read Blue LED Indicators
- Low Battery LEDs
- Inductive Clamp and Stereo Headset Included
The ProCaseTM is a professional-looking carrying case that is easy to bring with you on the job and holds all the essentials. The mesh section can hold wipes, wire nuts, cords, etc.
- Hard Shell Plastic Case with Steel Hinges
- Firm Foam Insert Custom Fit for Testers and Strippers
- Mesh Pouch for Cords and Smaller Accessories
- Replaceable Latches
The Armada Technologies Pro2TK 2-Wire Tool Kit consists of everything necessary to test 2-Wire Irrigation Systems, all stored in one place.
Pro2TK Includes:
- Pro50™ DigitalTester
- Pro95i™ Milliamp Clamp Multimeter
- Pro55™ Stainless Steel Wire Strippers
- Pro210F™ Tone Probe
- Scrubbuz Wipes
- ProCase™
Activate, Chatter, Test AC and DC Systems, Power Up 2-wire Systems
The brand new Pro50™ from Armada, features improved technology that topples that of old, antiquated solenoid testers. As digital processors can be programmed to deal with any situation, digital is the best way to test, activate, chatter, and diagnose. These digital capabilities allow the Pro50™ to test AC, DC, high resistance, and any low-voltage solenoid out there as well as power up a 2-wire system. The digital LCD screen sets it apart from older analog models, but the digital multimeter is what really separates them. This digital multimeter allows users to power up 2-wire systems with its own button for ease of use. Since different solenoids have different resistances, the digital multimeter diagnoses actual voltages and resistances. This lets users decide what is good and what is not. For example, old solenoid testers are hard-wired for a 20 to 60-ohm good range. Some DC solenoids read less than 20 ohms and will be diagnosed as short. On the Armada Pro50™, a 4-ohm solenoid reads as 4 ohms, thereby correctly identifying it as a good working solenoid. Digital is smarter.
In addition to digital features, the Pro50™ also sends a tracing tone for wire identification. The Pro50™ uses 4 AA batteries for longer life. For long-term affordability, the Pro50™ features 24-inch detachable alligator leads (cords) so that if they deteriorate, they are easily replaceable. All for about $30 more than the old solenoid testers. The kit includes the Pro50™, Pro210F™ Filter Probe, and a zippered carry case.
The Pro55 Armada Stainless wire strippers provide clean cuts through tough wires making your job smooth and easy. Water is no problem for the stainless composition of the Pro55. The stainless-steel feature gives the strippers long life and resistance against wear and tear in any field of work. The easy to grip handles provide for swift and quick movement while giving your hands some comfort. Precision holes allow for the perfect strip on each wire.
The 180 degree locking mechanism ensures no accidental locking of the strippers while in use.
• Stainless Steel
• Handles wire gauges 10-20 AWG
• Cushioned Grips
• Precision stripping blades
• Trims 8-32 and 6-32 steel bolts
• Bending holes for wire-forming
• Plier jaws with crimping jaw for electrical splices
Scrubbuz™ are designed to remove some of the toughest messes of gel and goo faced by contractors. Waterproof wire nuts and caps get messy. Hands, tools, and clothing get coated with the sticky material that won’t come off easily with simple wipes. Scrubbuz combination of dual coarse sides gives it more cleaning power than the average wipes. One side provides optimal scrubbing power with teeth to grab onto any rough stains. The other side finishes your clean with a smooth and soft polish. Infused with gel remover, greasy messes stand no chance against Scrubbuz™ extra strong material and cleaning formulation.
PRODUCT FEATURES
- Quickly removes silicone gunk
- Special dual-texture cloth surface
- Super size with 2X ordinary wiping area
- Stays moist longer – over an hour working time after opening
- Safe for your hands
- Resealable pack of 20
SPECIFICATIONS
Packaging: 10-pack point of purchase box with individual resealable packs
